• 목록
• 답변
• 글쓰기
• 게시판 리스트 옵션
  • 수정
  • 삭제

A siphon uses the physics of siphoning rather than a simple valve seal to move water from the cistern into the pan. Lifting the lever raises a plastic or rubber diaphragm inside the siphon body, which pushes a slug of water up and over a bend in the siphon tube, starting a siphoning action that then draws the rest of the cistern's contents down through the tube by suction until the water level drops low enough to break the siphon and stop the flush. This is why older cisterns produce that distinctive extended flush sound rather than the quicker valve-open, valve-close action of a modern flush valve.

The third check is worth doing before assuming either fault: isolate the water supply to the cistern, remove the fill valve, and Plumb2U UK inspect the seat and washer directly for scoring, grit or mineral buildup, particularly in hard water areas where limescale narrows the valve opening over months. A valve that looks visibly worn or scaled at the seat is the straightforward fix. A valve that looks clean and undamaged but the noise persists points more strongly toward mains pressure as the underlying cause.

Explore this further at toilet replacement parts supplier.

More information is available at plumbing spares supplier.

The second check is a knocking or banging sound, sometimes called water hammer, that happens specifically at the moment the fill valve shuts off rather than during the fill itself. This is far more often a mains pressure issue than a valve fault, caused by the sudden stop of a fast-moving column of water hitting the closed valve and sending a shock through the pipework. A fill valve replacement on its own will sometimes quieten this slightly, particularly if swapping to a bottom-entry valve which fills more gently, but it will not fully resolve a genuine water hammer problem, which usually needs an air-filled arrestor fitted at the supply if it persists.

A flush valve, by contrast, works as a straightforward seal at the base of the cistern that lifts to let water fall directly through into the pan under gravity, with no siphoning action involved, and shuts again once the float or timer mechanism allows it to reseat. Flush valves are what almost all dual-flush cisterns use, since a siphon's all-or-nothing action makes a genuine short flush difficult to achieve, whereas a valve can simply be held open for a shorter or longer period.